ELTIM PS-Power Supply modules

PS-modules (Power Supplies modules for our CS-modules amplifiers)






No supply caps, just making all required connections,
meaning that all 72 pins are connected as have to be.
Strongly recommended if a "foreign" supply is used.

  • Making all connections required between an external
       Power Supply and any CS-module (except CS-35/40/60ps).
  • V+, Ground and V- connected to 4mm² screw connector.
  • Germany made secondary fuse holders with dust cap.
  • MKP4 capacitors over the Supply rails.

This PS-0 is strongly recommended if you use another
power supply than an ELTIM PS-module as listed below.
We found out that some DIY'ers are not using all the available
CS-module connections, causing faults and errors.





 
Fits 2x 3 Ø18mm, 2x 2 Ø22mm or 2x Ø25mm caps.
Recommended for < 50Wrms amp setups.
     revised nov 2020!
  • Most basic Power Supply module for our CS-modules.
  • Rectifier based on 4x SMD Schottky diodes.
  • 2x relatively small supply capacitors on board.
  • With >50Wrms extra capacitance to be mounted!
  • Provided with two quality fuse holders in the power lines.
  • Recommended for use < 100Wrms.
  • Utraslim design, suitable for f.e. multichannel setups.
  • Required transformer is connected via a screw terminal.



PS-2 model (with cost effective capacitors here).
Fits 2x 2 Ø35/40mm, both 2- or 4-pin types.
     revised nov 2020!
  • L-mounted Power Supply module for all our CS-modules.
  • Fits all CS-modules except CS-35/35ps/40ps/60ps.
  • Rectifier based on four cooled schottky TO220 diodes 10A.
  • 4x large supply capacitors (selectable) on board:
          -  Ø35/40mm, pitch 10mm
          -  Ø40mm, 2-pole, 4-pin
  • Extra chassis mounted capacitors can be connected.
  • Provided with two quality fuse holders in the power lines.
  • Recommended for use < 250Wrms.
  • Required transformer is connected via a screw terminal.




Only fits very special true 4-pole capacitors (MLGO+ or ALN20S).
Extra space available for large MKP's over the voltage rails.
     NEW February 2021!
  • L-mounted Power Supply module for all our CS-modules.
  • Fits all CS-modules except CS-35/35ps/40ps/60ps.
  • Rectifier based on four cooled schottky TO220 diodes 10A.
  • 4x large true 4-pole supply capacitors (selectable) on board:
             - MUNDORF MLGO+, Ø30/35mm
             - KEMET ALN20S, Ø35/40mm (hard to get)
  • Extra chassis mounted capacitors can be connected.
  • Provided with two quality fuse holders in the power lines.
  • Recommended for use < 250Wrms.
  • Required transformer is connected via a screw terminal.


NOTE: other than mentioned 4-pin capacitors cannot be used
and will make a shortcut. These are plain 2-pole types with
just two extra mounting pins for mechanical stability.










For a correct VAT% calculation, please select your country: