ELTIM High-End In/out add-on modules

ELTIM Power Amplifier in/output modules:

Our modular setup makes it possible to connect one of the following modules to a side
of a VS-xx/CS-80 combination. Solderpads are then available very close to the chassis connectors,
so then there is hardly any wiring at all in our amplifier.




This line input board can be mounted left or right of CS-80 modules. In that case you only need short wires to
connect the line input and speaker terminals to it.

In addition you could mount a
high-end input capacitor (2,2uF) on this board.

We have left hand and right hand boards available.






This balanced input board can be mounted left or right
of CS-80 modules. In that case you only need short wires
to connect the XLR input and speaker terminals to it.
We use a very high quality balance to line driver IC
with a high quality audio transformer-like behaviour.
With this IC there are NO input capacitors required.

We have left hand and right hand boards available.


We can build similar modules for CS-120 and CS-165 as well on request.